Drug caution code
Ideal for chemical disinfection
For storage of soft, rigid, permeable or hard contact lenses
For storage of soft, rigid, permeable or hard contact lenses
Shape
NOT REQUIRED / OTHER
Sub brand name
N/A
U.P.C
063848960813
#NPN
N/A
#DIN
00000000
Content
0.0 / 0.0
For storage of soft (hydrophilic), rigid gas permeable (RGP), or hard contact lenses during chemical disinfection. For use in storage during chemical disinfection only. Do not use during heat disinfection. Before storing lenses, wash case with hot water. DO NOT USE any soaps, detergents or other household chemicals. After washing, RINSE THOROUGHLY with sterile disinfecting solution, depending on disinfection method to be used. When storing soft (hydrophilic) lenses, be sure to replace solution daily. Always clean your lenses as instructed by your eye care professional.
IMPORTANT: DO NOT try to remove a lens if the lens-well appears dry following the disinfecting cycle. Refill the well with fresh saline solution, recap tightly, and wait 30 to 40 minutes for the lens to rehydrate. If either well repeatedly dries out or leaks, the case should be replaced.
FOR CHEMICAL DISINFECTION:
1. Fill right lens-well 2/3 full with fresh sterile disinfecting solution, immerse right lens and twist screw-top cap on until tight.
2. Repeat same procedure with left lens-well and lens.
3. Wait the appropriate time as recommended for the solution used before removing lenses from the holder. BEFORE WEARING, rinse each lens thoroughly in STERILE SOLUTION as recommended for use with your lenses.
4. Immediately after lenses are removed, discard the old solution from the wells of the case. Rub the case with clean fingers for at least five seconds and rinse with the contact lens disinfecting solution. Air dry the case face down on a tissue with the caps off.
IMPORTANT: DO NOT try to remove a lens if the lens-well appears dry following the disinfecting cycle. Refill the well with fresh saline solution, recap tightly, and wait 30 to 40 minutes for the lens to rehydrate. If either well repeatedly dries out or leaks, the case should be replaced.
FOR CHEMICAL DISINFECTION:
1. Fill right lens-well 2/3 full with fresh sterile disinfecting solution, immerse right lens and twist screw-top cap on until tight.
2. Repeat same procedure with left lens-well and lens.
3. Wait the appropriate time as recommended for the solution used before removing lenses from the holder. BEFORE WEARING, rinse each lens thoroughly in STERILE SOLUTION as recommended for use with your lenses.
4. Immediately after lenses are removed, discard the old solution from the wells of the case. Rub the case with clean fingers for at least five seconds and rinse with the contact lens disinfecting solution. Air dry the case face down on a tissue with the caps off.
WARNING: NEVER HEAT LENSES IN STERILE DISINFECTING SOLUTION.
CAUTION: If pain or irritation occurs with lens wear, remove lenses and consult your eye care professional or physician immediately. KEEP OUT OF REACH OF CHILDREN.
CAUTION: If pain or irritation occurs with lens wear, remove lenses and consult your eye care professional or physician immediately. KEEP OUT OF REACH OF CHILDREN.